A. Coke oven
B. Blast furnace stoves
C. Beehive coke oven
D. High pressure boiler
Related Mcqs:
- In a furnace, the heat taken by the charge/stock and the heat lost to the furnace structure & flue gases depends on the__________________?
A. Rate of firing and emissivity of flame
B. Thermal conductivity of the charge & structural materials of furnace
C. Nature of process; whether batch, continuous or intermittent
D. All A., B. and C. - Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
A. 5
B. 60
C. 20
D. 40 - Which of the following is not a continuous waste heat recovery equipment from the flue gases going out of furnace ?
A. Economiser
B. Regenerator
C. Ceramic recuperator
D. Waste heat boiler - Which of the following is not an additive for flue gases from furnace to reduce its dewpoint ?
A. Ammonia
B. Fine dolomite
C. Alkaline powders
D. None of these - Artificial draught produced by a fan in the furnace can be controlled by the___________________?
A. Speed of the fan
B. Damper
C. Variation in the pitch of fan blades
D. All A., B. and C. - Which furnace employs preheating, heating and soaking zones ?
A. Soaking pit
B. Reheating furnace
C. Open hearth furnace
D. Cupola - Waste heat from the outgoing flue gases in a thermal power plant is recovered by a/an_________________?
A. Economiser
B. Steam superheater
C. Air preheater
D. All A., B. and C. - Flue gas outlet temperature from the chimney of any furnace should be ideally about ______________ °C?
A. 50
B. 100
C. 150
D. 250 - Oxygen percentage in the flue gas coming out of a gaseous fuel fired furnace should be ideally about _____________ percent?
A. < 2
B. < 5
C. < 8
D. < 10 - Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case of complete combustion of_________________?
A. Furnace oil with air
B. Furnace oil with oxygen
C. Blast furnace gas with air
D. Blast furnace gas with oxygen
