A. V2
B. 1/V2
C. 1/V
D. V
Related Mcqs:
- Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?
A. Δp
B. 2Δp
C. Δp2
D. Δp/2 - In case of turbulent flow of a Newtonian fluid in a straight pipe, the maximum velocity is equal to (where, Vavg = average fluid velocity)?
A. Vavg
B. 1.2 Vavg
C. 1.5 Vavg
D. 1.8 Vavg - For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) ?
A. μ
B. 1/μ
C. √μ
D. 1/√μ - A pipe has a porous section of length L as shown in the figure. Velocity at the start of this section of V0. If fluid leaks into the pipe through the porous section at a volumetric rate per unit area q(x/L)2, what will be axial velocity in the pipe at any „x‟? Assume incompressible one dimensional flow i.e., no gradients in the radial direction ?
A. VX = V0 + q (x3/L2D)
B. VX = V0 + ⅓q (x3/L2)
C. VX = V0 + 2q (x2/LD)
D. VX = V0 + (4/3) q (x3/L2D) - For turbulent flow in smooth circular pipe, the velocity distribution is a function of the distance ‘d’ measured from the wall of the pipe and the friction velocity ‘v’, and it follows a _____________ relationship?
A. Logarithmic
B. Linear
C. Hyperbolic
D. Parabolic - For turbulent flow of Newtonian fluid in a circular cross-section pipe, the ratio of maximum to average fluid velocity is ________________?
A. 0.5
B. 1
C. 0.66
D. < 0.5 - For turbulent flow of an incompressible fluid through a pipe, the flow rate „Q‟ is proportional to (Δ P)n, where ΔP is the pressure drop. The value of exponent ‘n’ is_________________?
A. 1
B. 0
C. < 1
D. > 1 - The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonian fluid in a circular pipe is_____________________?
A. 0.5
B. 1
C. 2
D. 0.66 - The head loss in turbulent flow in a pipe varies_________________?
A. Directly as the velocity
B. Inversely as the square of the velocity
C. Approximately as the square of the velocity
D. Inversely as the square of the diameter
