A. 24 Ω
B. 2.4 Ω
C. 300 Ω
D. 3,000 Ω
Related Mcqs:
- The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)___________?
A. 6.8 kΩ
B. 2.2 kΩ
C. 6.8 kΩ and 10 kΩ
D. 2.2 kΩ and 1 kΩ - A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately___________?
A. 14 mA
B. 1.4 mA
C. 5 mA
D. 50 mA - When a Wheatstone bridge is in a balanced condition, the center voltmeter in the bridge will read_____________?
A. twice the source voltage
B. half the source voltage
C. zero volts
D. the same as the source voltage - The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of____________?
A. 470 Ω or 1.2 kΩ
B. 3 kΩ
C. 470 Ω
D. 1.2 kΩ - The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 KΩ resistor is__________?
A. 25 %
B. 20 %
C. 100 %
D. 50 % - The parallel combination of a 470 Ω resistor and a 680 Ω resistor is in series with the parallel combination of four 2 kΩ resistors. The total resistance is___________?
A. 1,650 Ω
B. 1,078 Ω
C. 77.8 Ω
D. 778 Ω - A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is____________?
A. 680 Ω
B. 1,029 Ω
C. 200 Ω
D. 880 Ω - A Wheatstone bridge can be used to determine an unknown_____________?
A. current
B. voltage
C. resistance
D. power - A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
A. 10.9 V
B. 1.09 V
C. 1.1 V
D. 12 V - An RC high-pass filter consists of a 0.2 µF capacitor and a 220 Ω resistor. The output is taken across the resistor. The circuit’s critical frequency is_____________?
A. 723 Hz
B. 7,234 Hz
C. 362 Hz
D. 3,617 Hz
