Close circuit grinding by a ball mill with air sweeping employs a _______________________?

Related Mcqs:

1. The value of work index does not change materially from one equipment to another. If the value of work index determined for close circuit grinding is Wi, then the same for open circuit grinding will be_________________?

   A. 0.5 Wi
   B. Wi
   C. 1.34 Wi
   D. 3.34 Wi

2. A _____________ mill is a revolving mill divided into two or more sections by perforated partitions in which preliminary grinding takes place at one end and the finishing grinding at the discharge end?

   A. Compartment
   B. Tube
   C. Rod
   D. Pebble

3. Critical Speed (Nc) of a ball mill is given by (where R1 and R2 are radii of ball mill and the ball respectively) ?

   A. Nc = (1/4π). √(g/R1 – R2)
   B. Nc = (1/2π). √(g/R1 – R2)
   C. Nc = (1/π). √(g/R1 – R2)
   D. Nc = (1/2π). √(R1 – R2/g)

4. For achieving maximum capacity of the ball mill, the ball charge should be equal to about ______________ percent of the ball mill volume?

   A. 10
   B. 25
   C. 50
   D. 75

5. Power required to drive a ball mill with a particular ball load is proportional to (where, D = diameter of ball mill.) ?

   A. D
   B. 1/D
   C. D2.5
   D. 1/D2.5

6. In a ball mill, the volume occupied by the balls (when the mill is stopped) is about _______________ percent of the volume of the mill?

   A. 35
   B. 50
   C. 70
   D. 85

7. In closed circuit grinding as compared to open circuit grinding, the_________________?

   A. Specific surface of product is more
   B. Product has lesser size uniformity
   C. Production rate at a given limiting size is lower
   D. Operation is economical

8. Actual operating speed of a ball mill may vary from 65 to 80% of the critical speed. Which of the following duties would require the ball mill to be operated at maximum percentage of critical speed ?

   A. Wet grinding in low viscous suspension
   B. Wet grinding in high viscous suspension
   C. Dry grinding of large particles (upto 1.25 cms)
   D. Dry grinding of large particles in un-baffed mills

9. Wet grinding in a revolving mill ______________ as compared to dry grinding ?

   A. Gives less wear on chamber walls
   B. Requires more energy
   C. Increases capacity
   D. Complicates handling of the product

10. ______________________ balls capable of grinding the feed in a ball mill gives the maximum efficiency ?

    A. Cast iron
    B. Minimum size
    C. Maximum size
    D. Elliptical