A. Compartment
B. Tube
C. Rod
D. Pebble
Related Mcqs:
- Wet grinding in a revolving mill ______________ as compared to dry grinding ?
A. Gives less wear on chamber walls
B. Requires more energy
C. Increases capacity
D. Complicates handling of the product - In case of a revolving mill, wet grinding compared to dry grinding__________________?
A. Requires more energy
B. Has less capacity
C. Complicates handling & classification of the product
D. None of these - ______________ mill is not a revolving mill ?
A. Pebble
B. Compartment
C. Cage
D. Tube - In a ball mill, the volume occupied by the balls (when the mill is stopped) is about _______________ percent of the volume of the mill?
A. 35
B. 50
C. 70
D. 85 - Which of the following is not a revolving/tumbling mill used for size reduction ?
A. Compartment mill
B. Pebble mill
C. Cage mill
D. Rod mill - Which of the following grinding mills has the horizontally arranged rods as the grinding elements thereby delivering more uniform granular products with minimum fines ?
A. Compartment mill
B. Rod mill
C. Pebble mill
D. Tube mill - The value of work index does not change materially from one equipment to another. If the value of work index determined for close circuit grinding is Wi, then the same for open circuit grinding will be_________________?
A. 0.5 Wi
B. Wi
C. 1.34 Wi
D. 3.34 Wi - Work index is the gross energy (kWh/tonne of feed) necessary to reduce a very large feed to such a size that 80% of product particles will pass through a 0.1 mm screen. The value of work index determined for wet grinding should be multiplied with ______________ to get the same for dry grinding?
A. 1.0
B. 0.5
C. 1.34
D. 4.34 - Use of ‘grinding aids’ is done in _______________ grinding?
A. Dry
B. Wet
C. Ultrafine
D. Intermediate - In closed circuit grinding as compared to open circuit grinding, the_________________?
A. Specific surface of product is more
B. Product has lesser size uniformity
C. Production rate at a given limiting size is lower
D. Operation is economical
