A. Decreases rapidly
B. Increases rapidly
C. Remain constant
D. Is maximum
Related Mcqs:
- With increase in the liquid flow rate at a fixed gas velocity in a randomly packed counter current gas-liquid absorption column, the gas pressure drop___________________?
A. Decreases
B. Remains unchanged
C. Increases
D. Decreases exponentially - At the same gas flow rate, the pressure drop in a packed tower being irrigated with liquid _______________ that in dry packed tower ?
A. Is greater than
B. Is lower than
C. Is same as
D. Cannot be predicted as data are insufficient - Operating velocity in a packed tower is usually __________________ the flooding velocity ?
A. Half
B. Twice
C. Equal to
D. More than - Pressure drop through plate tower as compared to that through packed tower, for the same duty will be___________________?
A. Less
B. More
C. Equal
D. Either A. or B.; depends on the packing height - The reason for preferring packed towers over plate towers in distillation practice is that the packed tower operation gives___________________?
A. Low pressure drop and high hold up
B. High pressure drop and low hold up
C. Low pressure drop and low hold up
D. High pressure drop and high hold up - In a moderately sized packed absorption tower, channelling (which is most severe with stacked packings) can be minimised by taking the ratio of tower diameter to packing diameter ?
A. > 4 :1
B. < 8 : 1
C. > 8:1
D. < 6:1 - A packed tower compared to a plate tower for a particular mass transfer operation__________________?
A. Incurs smaller pressure drop
B. Allows installation of cooling coils
C. Is less costly when built in large sizes/diameters
D. Is more suitable, if suspended solids are present in fluid streams - Out of the following gas-liquid contacting devices, for a given set of operating conditions, gas pressure drop is the least in ______________ tower?
A. Wetted wall
B. Bubble cap
C. Perforated tray
D. Packed - In a packed tower, the value of HETP equals HTUOG, when the equilibrium and the operating lines are (where, HETP = height equivalent to a theoretical plate HTUOG = overall gas phase height of a transfer unit) ?
A. Straight
B. Parallel
C. Both A. & B.
D. Neither A. nor B. - For the gas absorption, the height of a transfer unit, based on the gas phase is given by (G: superficial molar gas velocity, L: superficial molar liquid velocity, FG: mass transfer co-efficient, moles/m2, a: interfacial area per unit volume of tower) ?
A. G/(FG . a)
B. FG/(G . a)
C. (G . a)/FG
D. L/(FG . G)