A. 4
B. 8
C. 9
D. 10
Related Mcqs:
- When acetone is added in a two layer mixture of methyl isobutyl ketone and water at 30°C, the acetone distributes between the two layers and the composition of the layer follows two solubility curves. For this system ?
A. As the acetone concentration increases, the solubility curves approach each other
B. Both the phases become identical at a particular common point on both the solubility curves
called the plait point
C. The distribution curve which is a plot between x (acetone concentration in one phase) and y
(acetone concentration in other phase) is analogous to x-y curve used in distillation and
absorption terminates on the x = y diagonal at the concentration of the plait point
D. All A., B. and C. - In a liquid-liquid extraction, 10 kg of a solution containing 2 kg of solute C and 8 kg of solvent A is brought into contact with 10 kg of solvent B. Solvent A and B are completely immiscible in each other whereas solute C is soluble in both the solvents. The extraction process attains equilibrium. The equilibrium relationship between the two phases is Y* = 0.9X, where Y* is the kg of C/kg of B and X is kg of C/kg of A. Choose the correct answer?
A. The entire amount of C is transferred to solvent B
B. Less than 2 kg but more than 1 kg of C is transferred to solvent B
C. Less than 1 kg of C is transferred to B
D. No amount of C is transferred to B - Compound A is extracted from a solution of A + B into a pure solvent S. A Co-current unit is used for the liquid-liquid extraction. The inlet rate of the solution containing A is 200 moles of B/hr.m2 and the solvent flow, rate is 400 moles of S/m2. hr. The equilibrium data is represented by Y = 3X2 , where Y is in moles of a A/moles of B and X is in moles A/moles of S. The maximum percentage extraction achieved in the unit is_________________________?
A. 25%
B. 50%
C. 70%
D. 90% - At equilibrium the concentration of water in vapour phase (C*) in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C* = 0.0667m. To maintain dry conditions in a room of air space 100m3 containing 2.2 kg of water vapour initially, 10 kg of dry silica gel is kept in the room. The fraction of initial water remaining in the air space after a long time (during which the temperature is maintained constant) is_________________?
A. 0.0
B. 0.2
C. 0.4
D. 1.0 - An air-water vapour mixture has a dry bulb temperature of 60°C and a dew point temperature of 40°C. The total pressure is 101.3 kPa and the vapour pressure of water at 40°C and 60°C are 7.30 kPa and 19.91 kPa respectively. The humidity of air sample expressed as kg of water vapour/kg of dry air is__________________?
A. 0.048
B. 0.079
C. 0.122
D. 0.152 - If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?
A. L/G
B. G/L
C. Always < 1
D. None of these - H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in meters) corresponding to an operating line given by, y = 5x + 0.001 is ______________________?
A. 2.0
B. 1.56
C. 1.0
D. 0.56 - The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is_____________________?
A. 0
B. ∞
C. -ve
D. +ve - The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is__________________?
A. 0
B. ∞
C. -ve
D. +ve - Which of the following quantities need not be fixed before starting the design of a cocurrent absorber ?
A. Heat gain or loss
B. Flow rate of entering liquid
C. Flow rate of gas
D. None of these
