The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is_____________________?

Related Mcqs:

1. The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is__________________?

   A. 0
   B. ∞
   C. -ve
   D. +ve

2. For a single component absorber, the operating line is straight only when plotted in term of ______________ units?

   A. Partial pressure
   B. Mole ratio
   C. Mole fraction
   D. None of these

3. The operating line for an absorber is curved, when plotted in terms of _______________________?

   A. Mole fractions
   B. Mole ratios
   C. Partial pressure
   D. Mass fractions

4. Acetone is to be removed from air in an isothermal dilute absorber using pure water as solvent. The incoming air contains 5 mole% of acetone (yin = 0.05). The design equation to be used for obtaining the number of trays (N) of the absorber is, N+2 = 6 log (yin/yout).For 98% recovery of acetone, the number of trays required is/are ?

   A. 4
   B. 8
   C. 9
   D. 10

5. H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in meters) corresponding to an operating line given by, y = 5x + 0.001 is ______________________?

   A. 2.0
   B. 1.56
   C. 1.0
   D. 0.56

6. When both the fluids flow concurrently in an absorber, the slope of the operating line is____________________?

   A. -ve
   B. +ve
   C. 1
   D. -1

7. If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?

   A. L/G
   B. G/L
   C. Always < 1
   D. None of these

8. Absorption factor is defined as (where, S1 = slope of the operating line S2 = slope of the equilibrium curve) ____________________?

   A. S2/S1
   B. S1/S2
   C. S1 – S2
   D. S1 × S2

9. Relative volatility varies with the concentration of component for an ideal solution. The relative volatility of a binary mixture may be defined as the ratio of vapor pressure of component ‘A’ to that of component ‘B’, when_________________?

   A. Only vapor phase follows Raoult’s law
   B. Only liquid phase obeys Dalton’s law
   C. Liquid phase obeys Dalton’s law and vapor phase obeys Raoult’s law
   D. Vapor phase obeys Dalton’s law and liquid phase obeys Raoult’s law

10. For an absorber, both equilibrium and operating line will be straight for _______________________?

    A. Concentrated solution and non-isothermal operation
    B. Dilute solution and non-isothermal operation
    C. Dilute solution and isothermal operation
    D. Concentrated solution and isothermal operation