A. S < 0.05% and P < 0.05%
B. S < 0.05% and P < 1.5%
C. S 1.5%
D. S > 1.5% and P < 0.05%
Related Mcqs:
- Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process ?
A. Galvanising
B. Tinning
C. Sherardizing
D. None of these - Volumetric composition of flue gas analysed with the Orsat apparatus is : CO2 = 12%, O2 = 8%, CO = nil, N2 = 80%. This flue gas composition indicates that_________________?
A. Pure oxygen has been used for combustion
B. Nitrogen percentage in the fuel is very high
C. Excess air has been used for combustion
D. Hydrogen is not present in the fuel - Volume of blast furnace slag is about _______________ times the volume of hot metal (pig iron) of the same weight ?
A. 1.5
B. 3
C. 5
D. 7 - Specific gravity of hot metal (pig iron) is ______________ times that of the blast furnace slag ?
A. 2
B. 3
C. 0.8
D. 6 - Solidification time of a molten metal in a casting is proportional to (where, V = volume of metal & A = its surface area; in the casting) ?
A. V/A
B. V/A2
C. V2/A
D. V2/A2 - The process of removal of scale formed during hot rolling of steel is termed as_________________?
A. Descaling
B. Shot blasting
C. Pickling
D. Skimming - Powder metallurgy process does not make metal powder by_________________________?
A. Atomisation
B. Grinding/milling
C. Hammering
D. Electrolytic deposition - ____________ is the process used for setting up compressive stresses in the surface of a metal to improve its fatigue strength ?
A. Lancing
B. Shot peening
C. Slugging
D. Spinning - In a drilling process, the metal is removed by both shearing & extrusion. General purpose drills are made of_________________?
A. Stainless steel
B. Mild steel
C. High speed steel
D. High carbon steel - Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare pipe surface located in a room without fans ?
A. Emissivity of pipe surface
B. Diameter & length of the pipe
C. Temperature of hot pipe surface & that of air in the room
D. None of these
