A. 550-600
B. 450-500
C. 350-400
D. 250-300
Related Mcqs:
- Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process ?
A. Galvanising
B. Tinning
C. Sherardizing
D. None of these - Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - In extrusion of metals, which of the following statement is true ?
A. Speed of the extruded material is same as that of ram speed
B. Redundant work is a function of the die angle
C. Relative motion between the billet surface and the container wall is always present
D. Hollow ram is used for indirect extrusion - In a drilling process, the metal is removed by both shearing & extrusion. General purpose drills are made of_________________?
A. Stainless steel
B. Mild steel
C. High speed steel
D. High carbon steel - A solid aluminium ball, when quenched in a water bath maintained at 40°C, cools down from 550°C to 450°C in 20 seconds. The expected temperature of the ball after next 20 seconds may be about ____________________ °C?
A. 370
B. 340
C. 320
D. 300 - _____________ is the process of coating the surface of steel with aluminium oxide, thereby imparting it increased resistance to corrosion & oxidation upto a temperature of 700°C ?
A. Veneering
B. Galvanising
C. Electroplating
D. Calorising - High relative humidity decreases the evaporative process and as the temperature is increased, the relative humidity decreases. The comfort range for human body is the ambient temperature of 22 to 27°C with relative humidity ranging from _______________ percent ?
A. 5 to 10
B. 15 to 25
C. 45 to 50
D. 75 to 80 - Which of the following metals cannot be hot worked at room temperature ?
A. Zinc
B. Nickel
C. Lead
D. Tin - In a counter flow heat exchanger, hot fluid enters at 170°C & leaves at 150°C, while the cold fluid enters at 50°C & leaves at 70°C. The arithmetic mean temperature difference in this case is ______________ °C?
A. 20
B. 60
C. 120
D. ∞ - Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type________________?
A. Parallel flow with equal heat capacities
B. Counter flow with equal heat capacities
C. Counter flow with unequal heat capacities
D. Parallel flow with unequal heat capacities
