A. Zinc
B. Nickel
C. Lead
D. Tin
Related Mcqs:
- The ratio of thermal & electrical conductivity is same for all the metals at the same temperature; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K) ?
A. T
B. 1/T
C. T2
D. 1/T2 - Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?
A. Tempering
B. Hardening
C. Annealing
D. Normalising - Which of the following parameters is not responsible for the heat loss from a hot steam carrying bare pipe surface located in a room without fans ?
A. Emissivity of pipe surface
B. Diameter & length of the pipe
C. Temperature of hot pipe surface & that of air in the room
D. None of these - Hot dipping process is used for coating a low melting point metal (e.g. Pb, Sn, Zn) on iron, steel & copper having relatively higher melting points. Which of the following is not a hot dipping process ?
A. Galvanising
B. Tinning
C. Sherardizing
D. None of these - While the recrystallisation temperature for pure metals is 0.3 Tm, the same for alloys is equal to ______________ × Tm (where, Tm Melting temperature) ?
A. 0.25
B. 0.45
C. 0.70
D. 0.95 - Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of ______________ will facilitate the most accurate measurement of the temperature ?
A. Copper
B. Steel
C. Aluminium
D. Brass - Corrosion of metals cannot be prevented by its__________________?
A. Tempering
B. Chromising
C. Aluminising
D. Alloying - Change in volume of metals from absolute zero temperature to their melting points is___________________?
A. Almost same for all metals
B. Different for different metals
C. Less for low melting point metals
D. Less for high melting point metals - Super conduction in metals is observed at a temperature of ________________ °K?
A. <100
B. >100
C. About 273
D. About 373 - Temperature attained in soldering of metals is about ________________ °C?
A. 150-300
B. 400-500
C. 650-800
D. 1000-1100
