A. yes
B. no
C. sometimes
D. rarely
E. very often
Related Mcqs:
- The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
A. larger
B. smaller
C. equal
D. larger/smaller depending on diameter of spring coil
E. unpredictable - When a close coiled helical spring is compressed, its wire is subjected to________________?
A. tension
B. shear
C. compression
D. all of the above
E. none of the above - The property of a material which enables it to resist fracture due to high impact loads is known as__________________?
A. elasticity
B. endurance
C. strength
D. toughness
E. resilience - If a material fails below its yield point, failure would be due to___________________?
A. straining
B. fatigue
C. creep
D. sudden loading
E. impact loading - Yield point in fatigue loading as compared to static loading is__________________?
A. same
B. higher
C. lower
D. depends on other factors
E. none of the above - A stud________________________?
A. has a head on one end and a nut fitted to the other
B. has head at one end and other end fits into a tapped hole in the other part to be joined
C. has both the ends threaded
D. has pointed threads
E. requires locking nuts - Transverse fillet welded joints are designed for________________?
A. tensile strength
B. compressive strength
C. shear strength
D. bending strength
E. torsional strength - The strap end of a connecting rod of steam engine is joined by_________________?
A. gib of cotter joint
B. sleeve and cotter joint
C. spigot socket cotter joint
D. knuckle joint
E. universal coupling - Allen bolts are___________________?
A. self locking bolts
B. designed for shock load
C. used in aircraft application
D. provided with hexagonal depression in head
E. uniform strength bolts - Elastic nut is a locking device in which__________________?
A. one small nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
B. a slot is cut partly in middle of nut and then slot reduced by tightening a screw
C. hard fiber or nylon cotter is recessed in the nut and becomes threaded as the nut is stewed on the bolt causing a tight grip
D. through slots are made at top and a cotter-pin is passed through these and a hole in the bolt, and cotter pin splitted and bent in reverse direction at other end
E. none of the above
