In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________________?

Related Mcqs:

1. If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?

   A. 0.2
   B. 0.25
   C. 0.50
   D. 0.6
   E. 0.75

2. The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be_________________?

   A. same in both cases
   B. 2 times more
   C. 3 times more
   D. 4 times more
   E. unpredictable

3. If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?

   A. lOVZ
   B. 10VZtol5Vd
   C. 15Vdto20VZ
   D. 20Vdto30Vd
   E. 30V5″to40Vd

4. Basic hole is one_________________?

   A. whose upper deviation is zero
   B. whose lower deviation is zero
   C. whose lower as well as upper deviations are zero
   D. does not exist
   E. none of the above

5. The edges of a boiler plate are bevelled to an angle of______________?

   A. 30°
   B. 45°
   C. 60°
   D. 80°
   E. 85°.

6. If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?

   A. diameter of bolt
   B. 0.75 x diameter of bolt
   C. 1.25 x diameter of bolt
   D. 1.5 x diameter of bolt
   E. 0.5 x diameter of bolt

7. In order to obtain bolt of uniform strength____________________?

   A. increase shank diameter
   B. increase its length
   C. drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread
   D. tighten die bolt properly
   E. all of the above

8. In order to permit the thermal expansion/contraction of tubing, it should be______________?

   A. crimped
   B. honed
   C. flared
   D. bent
   E. none of the above

9. When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?

   A. shank
   B. head
   C. in the middle
   D. at the thread
   E. anywhere in the bolt

10. A hot short metal is_________________?

    A. brittle when cold
    B. brittle when hot
    C. brittle under all conditions
    D. ductile at high temperature
    E. hard when hot