A. major diameter
B. minor diameter
C. pitch diameter
D. core diameter
E. none of the above
Related Mcqs:
- If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square
B. acme
C. buttress
D. BSW
E. metric - A self locking screw has________________>
A. fine threads
B. coarse threads
C. coefficient of friction > tangent of load angle
D. hole for inserting split pin
E. two nuts for locking - For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
A. ISO metric thread
B. acme thread
C. square thread
D. buttress thread
E. British Association thread - For tight leakage joints, following type of thread is best suited ____________________?
A. metric
B. buttress
C. square
D. acme
E. NPT (national pipe threads) - If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
A. lOVZ
B. 10VZtol5Vd
C. 15Vdto20VZ
D. 20Vdto30Vd
E. 30V5″to40Vd - If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
A. 102 d
B. 124 d
C. 138 d
D. 151 d
E. 168 d - The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?
A. 0.01 micron
B. 0.1 micron
C. 1 micron
D. 10 microns
E. 25 microns - If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?
A. 0.2
B. 0.25
C. 0.50
D. 0.6
E. 0.75 - Form coefficient of spring is _____________________?
A. ratio of coil diameter to wire diameter
B. load required to produce unit deflection
C. its capability of storing energy
D. concerned With strength of wire of spring
E. nothing - Jam nut is a locking device in which _____________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
B. a slot is cut partly in middle of nut and then slot reduced by tightening a screw
C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the nut is screwed on the bolt causing a tight grip
D. through slots are made at top and a cotter-pin is passed through these and a hole in the bolt, and cotter spitted and bent in reverse direction at other end
E. none of the above
