A. same
B. 1/2
C. 1/3
D. 1/4
E. 2/3
Related Mcqs:
- The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
A. 1 : l
B. 2:1
C. 3 : 2
D. 2 : 3
E. 1 : 2 - For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately________________?
A. 0.4 times
B. 0.6 times
C. 0.7 times
D. 0.8 times
E. 0.9 times the normal diameter of bolt - The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of____________?
A. 0.25
B. 0.45
C. 0.55
D. 0.65
E. 0.75 - Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
A. Brinell
B. Rockwell
C. Vicker
D. Shore’s sceleroscope
E. none of the above - The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
A. 0.33
B. 0.4
C. 0.5
D. 0.55
E. 0.6 - Shear stress theory is applicable for____________________?
A. ductile fnaterials
B. brittle materials
C. elastic materials
D. all of the above
E. none of the above - The shear plane in case of bolts should_________________?
A. be across threaded portion of shank
B. be parallel to axis of bolt
C. be normal to threaded portion of shank
D. never be across the threaded portion
E. none of the above - If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
A. 102 d
B. 124 d
C. 138 d
D. 151 d
E. 168 d - The connecting rod bolts are tightened up with initial tension greater than the external load so that___________________?
A. joint may not open up
B. bolts are weakest elements
C. the resultant load on the bolt would not be affected by the external cyclic load
D. bolts will not loosen during service
E. none of the above - Fatigue strength can be increased by__________________?
A. cold working
B. shot peening
C. grinding and lapping surface
D. hot working
E. using gradual changes of section
