Resilience of a material is considered when it is subjected to_________________?

Related Mcqs:

1. Proof resilience per material is known as________________?

   A. resilience
   B. proof resilience
   C. modulus of resilience
   D. toughness
   E. impact energy

2. Shear stress induced in a shaft subjected to tension will be__________________?

   A. maximum at periphery and zero at center
   B. maximum at center
   C. uniform throughout
   D. average value in center
   E. none of the above

3. A key is subjected to side pressure as well at shearing forces. These pressures are called_________________?

   A. bearing stresses
   B. fatigue stresses
   C. crushing stresses
   D. resultant stresses
   E. none of the above

4. A boiler shell 200 cm diameter and plate thickness 1.5 cm is subjected to internal pressure of 1.5 MN/m , then the hoop stress will be_________________?

   A. 30 MN/m2
   B. 50 MN/m2
   C. 100 MN/m2
   D. 200 MN/m2
   E. 300 MN/m2

5. The deformation of a bar under its own weight compared to the deformation of same body subjected to a direct load equal to weight of the body is_______________?

   A. same
   B. double
   C. half
   D. four times
   E. one-fourth

6. The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular stresses of equal intensity, is equal to___________________?

   A. Young’s modulus
   B. bulk modulus
   C. modulus of rigidity
   D. modulus of elasticity
   E. Poisson’s ratio

7. A flywheel on a motor goes from rest to 1000 rpm in 6 sec. The number of revolutions made is nearly equal to_________________?

   A. 25
   B. 50
   C. 100
   D. 250
   E. 500

8. The change in the unit volume of a material under tension with increase in its Poisson’s ratio will ________________?

   A. increase
   B. decrease
   C. remain same
   D. increase initially and then decrease
   E. unpredictable

9. Tensile strength of a material is obtained by dividing the maximum load during the test by the_________________?

   A. area at the time of fracture
   B. original cross-sectional area
   C. average of A. and B.
   D. minimum area after fracture
   E. none of the above.

10. The stress developed in a material at breaking point in extension is called__________?

    A. Breaking stress
    B. Fracture stress
    C. Yield point stress
    D. Proof stress

    Submitted by: Faheem Zaman Dhaunroo