A. same
B. more
C. less
D. depends on other factors
E. none of the above
Related Mcqs:
- LMTD in case of counter flow heat exchanger as compared-to parallel flow heat exchanger is _________________?
A. higher
B. lower
C. same
D. depends on the area of heat exchanger
E. depends on temperature conditions - In counter flow heat exchangers_________________?
A. both the fluids at inlet (of heat ex¬changer where hot fluid enters) are in their coldest state
B. both the fluids at inlet are in their hot¬test state
C. both the fluids .at exit are in their hottest state
D. one fluid is in hottest state and other in coldest state at inlet
E. any combination is possible depending on design of heat exchanger - Two balls of same material and finish have their diameters in the ratio of 2 : 1 and both are heated to same temperature and allowed to cool by radiation. Rate of cooling by big ball as compared to smaller one will be in the ratio of____________________?
A. 1 :1
B. 2: 1
C. 1 : 2
D. 4 : 1
E. 1 : 4 - Heat conducted througfi unit area and unit thick face per unit time when temperature difference between opposite faces is unity,is called__________________?
A. thermal resistance
B. thermal coefficient
C. temperature gradient
D. thermal conductivity
E. heat-transfer - In convection heat transfer from hot flue gases to water tube, even though flow may be turbulent, a laminar flow region (boundary layer of film) exists close to the tube. The heat transfer through this film takes place by___________________?
A. convection
B. radiation
C. conduction
D. both convection and conduction
E. none of the above - Total emissivity of polished silver compared to black body is___________________?
A. same
B. higher
C. more or less same
D. very much lower
E. very much higher - In heat exchangers, degree of approach is defined as the difference between temperatures of________________?
A. cold water inlet and outlet
B. hot medium inlet and outlet
C. hot medium outlet and cold water inlet
D. hot medium outlet and cold water outlet
E. none of the above - Which of the following is the case of heat transfer by radiation ___________________?
A. blast furnace
B. heating of building
C. cooling of parts in furnace
D. heat received by a person from fireplace
E. all of the above - Which of the following is a case of steady state heat transfer ___________________?
A. I.C. engine
B. air preheaters
C. heating of building in winter
D. all of the above
E. none of the above - The concept of overall coefficient of heat transfer is used in case of heat transfer by________________?
A. conduction
B. convection
C. radiation
D. conduction and convection
E. convection and radiation
