A. accumulating oil
B. supplying large quantities of oil for very short duration
C. generally high pressures to operate hydraulic machines
D. supplying energy when main supply fails
E. accumulating hydraulic energy
Related Mcqs:
- A hydraulic accumulator normally consists of________________?
A. two cylinders, two rams and a storage device
B. a cylinder and a ram
C. two co-axial rams and two cylinders
D. a cylinder, a piston, storage tank and control valve
E. special type of pump with storage device and a pressure regulator - Reaction turbines are used for____________________?
A. low head
B. high head
C. high head and low discharge
D. high head and high discharge
E. low head and high discharge - Maximum impulse will be developed in hydraulic ram when ___________________?
A. waste valve closes suddenly
B. supply pipe is long
C. supply pipe is short
D. ram chamber is large
E. supply pipe has critical diameter - A hydraulic intensifier normally consists of __________________?
A. two cylinders, two rams and a storage device
B. a cylinder and a ram
C. two co-axial rams and two cylinders
D. a cylinder, a piston, storage tank and control valve
E. special type of pump with storage device and a pressure regulator - Which place in hydraulic turbine is most susceptible for cavitation __________________?
A. inlet of draft rube
B. blade inlet
C. guide blade
D. penstock
E. draft tube exit - Runaway speed of a hydraulic turbine is_________________?
A. full load speed
B. the speed at which turbine runner will be damaged
C. the speed if the turbine runner is allowed to revolve freely without load and with the wicket gates wide open
D. the speed corresponding to maximum overload permissible
E. none of the above. - The hydraulic turbines are also known as : ___________?
A. steam turbines
B. water turbines
C. combustion turbines
D. Gas turbinesSubmitted by: Faheem Zaman Dhaunroo
- When a piping system is made up primarily of vertical lift and very little pipe friction, the pump characteristics should be _________________?
A. horizontal
B. nearly horizontal
C. steep
D. first rise and then fall
E. none of the above - In centrifugal pumps, maximum efficiency is obtained when the blades are_________________?
A. straight
B. bent forward
C. bent backward
D. radial
E. given aerofoil section - According to fan laws, at constant speed and capacity, the pressure and power vary_____________________?
A. directly as the air or gas density
B. inversely as square root of density
C. inversely as density
D. as square of density
E. as square root of density