A. less than d
B. equal to d
C. more than d
D. any of the above
where d is the diameter of the cylindrical part
Related Mcqs:
- The minimum thickness of plates in a steel stack should be___________________?
A. 4 mm
B. 5 mm
C. 6 mm
D. 8 mm - In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?
A. fully by direct bearing
B. fully through fastenings
C. 50% by direct bearing and 50% through fastenings
D. 75% by direct bearing and 25% through fastenings - The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?
A. 1.0 mm
B. 1.5 mm
C. 2.0 mm
D. 2.5 mm - The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
A. 95.0 MPa on net area
B. 105.5 MPa on net area
C. 105.5 MPa on gross area
D. 150.0 MPa on gross area - According to IS Specifications, the maximum pitch of rivets in compression is_____________________?
A. lesser of 200 mm and 12 t
B. lesser of 200 mm and 161
C. lesser of 300 mm and 32 t
D. lesser of 3 00 mm and 24 t
where t is thickness of thinnest outside plate or angle - The shape factor of an isosceles triangle for bending about the axis parallel to the base is________________?
A. 1.5
B. 1.7
C. 2.0
D. 2.34 - The least dimension in case of a circular column of diameter D is taken as_______________?
A. 0.5 D
B. 0.68 D
C. 0.88 D
D. D - A steel beam supporting loads from the floor slab as well as from wall is termed as________________?
A. stringer beam
B. lintel beam
C. spandrel beam
D. header beam - The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be___________________?
A. 4.5 mm
B. 6 mm
C. 8 mm
D. 10 mm - If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
A. 0
B. 0.5
C. between 0.5 and 1.0
D. 1.0
