A. 0.67 L
B. 0.8 L
C. L
D. 1.5 L
Related Mcqs:
- The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?
A. 1.8 L
B. L
C. 1.1 L
D. 1.5 L - The effective length of a battened column is increased by_________________?
A. 5%
B. 10%
C. 15%
D. 20% - According to IS Specifications, the maximum pitch of rivets in compression is_____________________?
A. lesser of 200 mm and 12 t
B. lesser of 200 mm and 161
C. lesser of 300 mm and 32 t
D. lesser of 3 00 mm and 24 t
where t is thickness of thinnest outside plate or angle - The least dimension in case of a circular column of diameter D is taken as_______________?
A. 0.5 D
B. 0.68 D
C. 0.88 D
D. D - The slenderness ratio of a column supported throughout its length by a masonry wall is________________?
A. zero
B. 10
C. 100
D. infinity - The effective length of a fillet weld should not be less than___________________?
A. two times the weld size
B. four times the weld size
C. six times the weld size
D. weld size - If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
A. 0
B. 0.5
C. between 0.5 and 1.0
D. 1.0 - The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
A. 95.0 MPa on net area
B. 105.5 MPa on net area
C. 105.5 MPa on gross area
D. 150.0 MPa on gross area - A steel beam supporting loads from the floor slab as well as from wall is termed as________________?
A. stringer beam
B. lintel beam
C. spandrel beam
D. header beam - Lacing bars in a steel column should be designed to resist_________________?
A. bending moment due to 2.5% of the column load
B. shear force due to 2.5% of the column load
C. 2.5% of the column load
D. both (A) and (B)
