Force polygon method is applicable for_____________________?

Related Mcqs:

1. If the given forces P,, P2, P3 and P4 are such that the force polygon does not close, then the system will___________________?

   A. be in equilibrium
   B. always reduce to a resultant force
   C. always reduce to a couple
   D. both (A) and (C)

2. The force polygon representing a set of forces in equilibrium is a_____________________?

   A. triangle
   B. open polygon
   C. closed polygon
   D. parallelogram

3. An ordinate in a funicular polygon represents__________________?

   A. shear force
   B. resultant force
   C. bending moment
   D. equilibrium

4. A funicular polygon cannot be made to pass through___________________?

   A. one specified point
   B. two specified points
   C. three specified points
   D. more than three specified points

5. A force P of 50 N and another force Q of unknown magnitude act at 90° to each other. They are balanced by a force of 130 N. The magnitude of Q is__________________?

   A. 60 N
   B. 80 N
   C. 100 N
   D. 120 N

6. A rope is wrapped twice around a rough pole with a coefficient of friction ‘A . It is subjected to a force Fj at one end and a gradually increasing force F2 is applied at the other end till the rope just starts slip-ping. At this instant the ratio of F2 to Fi is_____________________?

   A. 1
   B. e2*
   C. e4*
   D. e*72

7. A flywheel of moment of inertia 20 kg-m” is acted upon by a tangential force of 5 N at 2 m from its axis, for 3 seconds. The increase in angular velocity in radian persecond is__________________?

   A. 1/2
   B. 3/2
   C. 2
   D. 3

8. The ratio of unit of force in gravitational system to that in absolute system is__________________?

   A. 1
   B. g
   C. 1/g
   D. none of the above
   where ‘g’ is acceleration due to gravity

9. In SI units, the units of force and energy are respectively___________________?

   A. Newton and watt
   B. Dyne and erg
   C. Newton and joule
   D. kg-wt and joule

10. The torque produced by a force depends on__________________?

    1) the magnitude of the force
    2) the direction of the force
    3) the’point of application of the force relative to origin
    The correct answer is?

    A. only (1)
    B. both (1) and (2)
    C. both (1) and (3)
    D. all (1), (2) and (3)