A. plasticity index to consistency index
B. plasticity index to flow index
C. liquidity index to flow index
D. consistency index to liquidity index
Related Mcqs:
- Select the correct range of density index,ID ________________?
A. lD>0
B. ID>0
C. 0 < lD < 1
D. 0 < ID < 1 - According to Atterberg, the soil is said to be of medium plasticity if the plasticity index PI is____________?
A. 0 < PI < 7
B. 7<PI< 17
C. 17<PI27 - If the plasticity index of a soil mass is zero, the soil is______________?
A. sand
B. silt
C. clay
D. clayey silt - When the plastic limit of a soil is greater than the liquid limit, then the plasticity index is reported as_____________?
A. negative
B. zero
C. non-plastic (NP)
D. 1 - Which of the following soils has more plasticity index ?
A. sand
B. silt
C. clay
D. gravel - The value of compression index for a remoulded sample whose liquid limit is 50% is______________?
A. 0.028
B. 0.28
C. 036
D. 0.036 - Sensitivity of a soil can be defined as___________________?
A. percentage of volume change of soil under saturated condition
B. ratio of compressive strength of unconfined undisturbed soil to that of soil in a remoulded state
C. ratio of volume of voids to volume of solids
D. none of the above - Voids ratio of a soil mass can_________________?
A. never be greater than unity
B. be zero
C. take any value greater than zero
D. take values between 0 and 1 only - If the water content of a fully saturated soil mass is 100%, then the voids ratio of the sample is________________?
A. less than specific gravity of soil
B. equal to specific gravity of soil
C. greater than specific gravity of soil
D. independent of specific gravity of soil - The hydraulic head that would produce a quick condition in a sand stratum of thickness 1.5 m, specific gravity 2.67 and voids ratio 0.67 is equal to_______________?
A. 1.0m
B. 1.5 m
C. 2.0 m
D. 3m