A. Anderson bridge
B. Maxwell’s bridge
C. Heaviside bridge
D. Any of the above
Related Mcqs:
- For measurement of inductance having high value, we should use______________?
A. Maxwell’s bridge
B. Maxwell Wein bridge
C. Hay’s bridge
D. Any of the above - If an inductance is connected in one arm of bridge and resistances in the remaining three arms____________?
A. the bridge can always be balanced
B. the bridge cannot be balanced
C. the bridge can be balanced if the resistances have some specific values - In an Anderson bridge, the unknown inductance is measured in terms of_______________?
A. known inductance and resistance
B. known capacitance and resistance
C. known resistance
D. known inductance - In a 3-phase power measurement by two wattmeter method, both the watt meters had identical readings. The power factor of the load was___________?
A. unity
B. 0.8 lagging
C. 0.8 leading
D. zero - Which of the following devices should be used for accurate measurement of low D.C. voltage ?
A. Small range moving coil voltmeter
B. D.C. potentiometer
C. Small range thermocouple voltmeter
D. None of the above - In a 3-phase power measurement by two wattmeter method the reading of one of the wattmeter was zero. The power factor of the load must be_______________?
A. unity
B. 0.5
C. 0.3
D. zero - Commonly used instruments in power system measurement are_______________?
A. induction
B. moving coil or iron
C. rectifier
D. electrostatic - The spring material used in a spring control device should have the following property?
A. Should be non-magnetic
B. Most be of low temperature co-efficient
C. Should have low specific resistance
D. Should not be subjected to fatigue
E. All of the above - The disc of an instrument using eddy current damping should be of________________?
A. conducting and magnetic material
B. non-conducting and magnetic material
C. conducting and non-magnetic material
D. none of the above - Basically a potentiometer is a device for________________?
A. comparing two voltages
B. measuring a current
C. comparing two currents
D. measuring a voltage
E. none of the above
