A. Current controlled Current source
B. Current controlled voltage source
C. Voltage controlled voltage source
D. voltage controlled current source
Related Mcqs:
- In deriving ac equivalent circuit for an amplifier circuit, we short circuit___________?
A. all resistors
B. all transistors
C. all inductors
D. all capacitors - An n- channel JFET has IDSS=2mA,and Vp=-4v.Its transconductance gm=in mA/V)for an applied gate to source voltage VGS=-2v is___________?
A. 0.25
B. 0.5
C. 0.75
D. 1 - The MOSFET switch in its on-state may be considered equivalent to_____________?
A. resistor
B. inductor
C. capacitor
D. battery - Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?
A. 49dB
B. 51dB
C. 98dB
D. 102dB - Which of the following amplifier circuit using junction transistor has the best gain?
A. Common base
B. Common emitter
C. Common collector
D. All have the same gain - A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are_____________?
A. 5 Ω & 20 %
B. 25 Ω & 20 %
C. 5 Ω & 16.7 %
D. 25 Ω & 16.7 % - In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
A. 23dB
B. 25dB
C. 46dB
D. 50dB - An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.
A. 10 volts
B. 5 volts
C. 5/1 volts
D. 5/2 volts - The bandwidth of an RF tuned amplifier is dependent on____________?
A. Q –factor of the tuned o/p circuit
B. Q –factor of the tuned i/p circuit
C. Quiescent operating point
D. Q-factor of the o/p and i/p circuits as well as quiescent operating point - The horizontal intercept of dc load line is the same as ideal____________?
A. cut off point
B. saturation point
C. operating point
D. quasi saturation point