A. The amount of heat generated can be controlled accurately
B. Heat at very high rate can be gene-rated
C. The area of the surface over which heat is produced can be accurately controlled
D. All of the above
Related Mcqs:
- Hysteresis loss and eddy current loss are used in____________?
A. induction heating of steel
B. dielectric heating
C. induction heating of brass
D. resistance heating - In resistance heating highest working temperature is obtained from heating elements made of_____________?
A. nickel copper
B. nichrome
C. silicon carbide
D. silver - For radiant heating around 2250°C, the heating elements are made of____________?
A. copper alloy
B. carbon
C. tungsten alloy
D. stainless steel alloy - In heating the ferromagnetic material by induction heating, heat is produced due to_____________?
A. induced current flow through the charge
B. hysteresis loss taking place below curie temperature
C. due to hysteresis loss as well as eddy current loss takingplace in the charge
D. none of the above factors - Which of the following is an advantage of heating by electricity ?
A. Quicker operation
B. Higher efficiency
C. Absence of flue gases
D. All of the above - Which of the following heating methods has maximum power factor ?
A. Arc heating
B. Dielectric heating
C. Induction heating
D. Resistance heating - Induction heating takes place it which of the following ?
A. Insulating materials
B. Conducting materials which are magnetic
C. Conducting materials which are non-magnetic
D. Conducting materials which may or may not be magnetic - Induction heating process is based on which of the following principles ?
A. Thermal ion release principle
B. Nucleate heating principle
C. Resistance heating principle
D. Electro-magnetic induction princi¬ple - Radiant heating is used for which of the following ?
A. Annealing of metals
B. Melting of ferrous metals
C. Heating of liquids in electric kettle
D. Drying of paints and varnishes - Properly of low temperature co-eflficient of heating element is desired due to which of the following reasons ?
A. To avoid initial rush of current
B. To avoid change in kW rating with temperature
C. Both (A) and (B)
D. Either (A) or (B)
