A. 25 to 35%
B. 40 to 60%
C. 70 to 80%
D. 90 to 95%
Related Mcqs:
- The ratio of ampere-hour efficiency to watt-hour efficiency of a lead-acid cell is____________?
A. just one
B. always greater than one
C. always less than one
D. none of the above - The ampere-hour efficiency of a lead acid cell is normally between_________?
A. 20 to 30%
B. 40 to 50%
C. 60 to 70%
D. 90 to 95% - In a lead-acid cell, if the specific gravity of sulphuric acid is 1.8, it will require following ratio of acid to water to get mixture of specific gravity of 1.3
A. 6 parts of acid to 4 parts of water
B. 4 parts of acid to 4 parts of water
C. 4 parts of acid to 6 parts of water
D. 4 parts of acid to 8 parts of water - As compared to a lead-acid cell, the efficiency of a nickel-iron cell is less due to its__________?
A. compactness
B. lower e.m.f.
C. small quantity of electrolyte used
D. higher internal resistance - In a lead-acid cell, lead is called as____________?
A. positive active material
B. negative active material
C. passive material
D. none of the above - In a lead-acid cell dilute sulfuric acid (electrolyte) approximately comprises the following__________?
A. one part H2O, three parts H2SO4
B. two parts H2O, two parts H2SO4
C. three parts H2O, one part H2SO4
D. all H2S04 - The internal resistance of an alkali cell is nearly _________ times that of the lead-acid cell
A. two
B. three
C. four
D. five - When the specific gravity of the electrolyte of a lead-acid cell is reduced to 1.1 to 1.15 the cell is in___________?
A. charged state
B. discharged state
C. both (A) and (B)
D. active state - On the average the ampere-hour efficiency of an Edison cell is about__________?
A. 40%
B. 60%
C. 70%
D. 80% - Electrolyte used in a lead-acid cell is__________?
A. NaOH
B. onlyH2S04
C. only water
D. dilute H2SO4
