A. flux/pole
B. speed of armature
C. number of poles
D. all of the above
Related Mcqs:
- The e.m.f. generated by a shunt wound D.C. generator isE. Now while pole flux remains constant, if the speed of the generator is doubled, the e.m.f. generated will be_______________?
A. E/2
B. 2E
C. slightly less than E
D. E - A shunt generator running at 1000 r.p.m. has generated e.m.f. as 200 V. If the speed increases to 1200 r.p.m., the generated e.m.f. will be nearly_______________?
A. 150 V
B. 175 V
C. 240 V
D. 290 V - Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be_______________?
A. 2 : 3
B. 3 : 1
C. 3 : 2
D. 1 : 3 - In a D.C. generator the ripples in the direct e.m.f. generated are reduced by_____________?
A. using conductor of annealed copper
B. using commutator with large number of segments
C. using carbon brushes of superior quality
D. using equiliser rings - Which of the following components of a D.C, generator plays vital role for providing direct current of a D.C. generator ?
A. Dummy coils
B. Commutator
C. Eye bolt
D. Equilizer rings - Welding generator will have____________?
A. lap winding
B. wave winding
C. delta winding
D. duplex wave winding - The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be_____________?
A. 640 V
B. 620 V
C. 600 V
D. 580 V - In a D.C. generator in case the resistance of the field winding is increased, then output voltage will____________?
A. increase
B. decrease
C. remain unaffected
D. fluctuate heavily - The purpose of providing dummy coils in a generator is____________?
A. to reduce eddy current losses
B. to enhance flux density
C. to amplify voltage
D. to provide mechanical balance for the rotor - With a D.C. generator which of the following regulation is preferred ?
A. 100% regulation
B. infinite regulation
C. 50% regulation
D. 1% regulation