A. Form an opening of molten metal to enter the mold
B. Help polish cast restorations
C. Eliminate air bubbles on the wax pattern
D. Reproduce fine detail
Related Mcqs:
- The sprue in wax pattern should be placed________________?
A. At right angle
B. At 45°C angle
C. At obtuse angle
D. It depend upon type of wax pattern - Disadvantage of having a short sprue is________________?
A. Rapid solidification of metal
B. No place for reservoirs
C. Incomplete evacuation of gases
D. Difficulty in removing casting from investment - Inlay wax is used to_______________?
A. Temporarily cement inlays:
B. Make inlay wax patterns
C. Invest inlay patterns
D. Box models - Casting flux is used to_______________?
A. Prevent the oxidation of the metal during melting
B. increase the melting point of the flux
C. Flaring the point of the sprue attachment
D. None of the above - Fins and spines on the casting is seen due to_______________?
A. Prolonged heating:
B. Rapid heating me
C. Water film contamination
D. Too high pressure during casting - A rough / Chalky surface of the cast is due to_______________?
A. Not waiting for 20 min before pouring
B. High speed accelerator
C. Air incorporation in the mix
D. All of the above - Type I and Type II zinc oxide impression paste differ with respect to_______________?
A. Their use
B. Their hardness after setting
C. Water content
D. Eugenol content - Flow of a material refers to_______________?
A. Continued change of the material under a given load
B. The consistency of material when mixing
C. The homogencity of gypsum products
D. Dimensional change of the material during settings - Space lattice refers to_______________?
A. Inter atomic movement
B. Inter atomic imbalance
C. Arrangement of atoms
D. Arrangement of molecules - Porosity of denture base is due to_______________?
A. Packing at dough stage
B. Curing at 160°F for 9 hrs
C. Inadequate pressure
D. All of the above