A. rectifier
B. inverter
C. chopper
D. regulator
Related Mcqs:
- For commutation in three phase PAC, normally balanced three phase voltages VR, VY and VB are connected to the three legs of the converter via______________?
A. Three inductances
B. Three capacitances
C. Three resistance
D. Three transistors - In a flyback converter, the inductor of the buck-boost converter has been replaced by a_____________?
A. Flyback capacitor
B. Flyback resistor
C. Flyback transformer
D. Flyback transistor - In a push – pull converter, the filter capacitor can be obtained as____________?
A. Cmin = V / ( Vr L f2 )
B. Cmin= ( 1 – D ) V / ( Vr L f2 )
C. Cmin= ( 1 – 2 D ) V / 32 ( Vr L f2 )
D. Cmin= ( 1 – 2 D ) V / 42 ( Vr L f2 ) - During the commutation period in 3 phase converter, overlap time is_____________?
A. Dependent on the load current
B. Dependent on the voltage
C. Dependent on both the load current and load voltage behind the short circuit current
D. Independent on both the load current and load voltage - In a three phase converter, the number of notches per cycle is____________?
A. One
B. Three
C. Six
D. Nine - During the commutation period in 3 phase converter, overlap time is____________?
A. Dependent on the load current
B. Dependent on the voltage
C. Dependent on both the load current and load voltage behind the short circuit current
D. Independent on both the load current and load voltage - In a 3 phase CSI, if the required line output voltages are balanced and 120 degree out of phase, then the chopping angles are used to eliminate only the harmonics at frequencies
A. 5
B. 7
C. 11
D. All of these - n a phase controlled 3 phase ac voltage controller, the harmonic present is__________?
A. 2nd
B. 3rd
C. 5th
D. 7th - A single phase full bridge inverter can operate in load commutation mode in case load consists of____________?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped. - Single phase VSI are mainly used in___________?
A. Power supplies
B. Ups
C. Multilevel configuration
D. All of these
