A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped.
Related Mcqs:
- A single phase full bridge inverter can operated in load commutation mode in case load consist of______?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped - Voltage commutation circuit can be converted into a current commutation by interchanging the positions of____________?
A. Diode and capacitor
B. Capacitor and SCR
C. Inductor and capacitor
D. Capacitor and load - For commutation in three phase PAC, normally balanced three phase voltages VR, VY and VB are connected to the three legs of the converter via______________?
A. Three inductances
B. Three capacitances
C. Three resistance
D. Three transistors - In a lossless inverter, the average power absorbed in one period by the load must be__________?
A. Equal to the average power supplied by the dc source
B. Greater than the average power supplied by the dc source
C. Lesser than the average power supplied by the dc source
D. Equal to the average power supplied by the ac source - A single phase one pulse controlled circuit has a resistance R and counter emf E load 400 sin(314 t) as the source voltage. For a load counter emf of 200 V, the range of firing angle control is _____?
A. 30° to 150°.
B. 30° to 180°.
C. 60° to 120°.
D. 60° to 180°. - During the commutation period in 3 phase converter, overlap time is_____________?
A. Dependent on the load current
B. Dependent on the voltage
C. Dependent on both the load current and load voltage behind the short circuit current
D. Independent on both the load current and load voltage - During the commutation period in 3 phase converter, overlap time is____________?
A. Dependent on the load current
B. Dependent on the voltage
C. Dependent on both the load current and load voltage behind the short circuit current
D. Independent on both the load current and load voltage - In a single phase full wave rectifier, during blocking state the pea inverse voltage of diode is______________?
A. V m
B. 2 V m
C. V m / 2
D. 4 V m - If energy is taken from the AC side of the inverter and sends it back into the DC side, then it is known as___________?
A. Motoring mode operation
B. Braking mode operation
C. Regenerative mode operation
D. None of these - In a full bridge VSI, in order to avoid the short circuit across the DC bus and the undefined AC output voltage condition, the modulating technique should ensure that___________?
A. Top switch of each leg is on at any instant
B. Bottom switch of each leg is on at any instant
C. Either A. or B.
D. None of these
