A. Ammonium carbonate
B. Biuret
C. Carbon dioxide
D. Ammonium carbamate
Related Mcqs:
- Prilling of urea should be accomplished (in a sprayer) just above the melting point of urea with minimum of retention time, otherwise it will result in__________________?
A. Low bulk density product
B. Biuret formation
C. Non-spherical prills
D. Substantially wet non-flowing and sticky product - An increase in the NH3/CO2 ratio in urea manufacture results in__________________?
A. Increased degree of conversion of CO2 to urea
B. Decreased degree of conversion of NH3 to urea
C. Decreased yield of urea
D. Decreased specific volume of molten mass - In the manufacture of urea, the intermediate chemical formed is__________________?
A. Biuret
B. Ammonium carbamate
C. Ammonium carbonate
D. None of these - Urea (a nitrogenous fertiliser) is produced from carbon dioxide and__________________?
A. Nitric acid
B. Ammonia
C. Ammonium nitrate
D. Nitric oxide - Nitrogen content of urea is about _____________ percent ?
A. 10
B. 46
C. 80
D. 94 - Dehydration of ammonium carbamate (to produce urea) is a/an _____________ reaction?
A. Reversible
B. Catalytic
C. Exothermic
D. Endothermic - Fertiliser produced during soda ash manufacture by dual process is ammonium______________________?
A. Chloride
B. Sulphate
C. Nitrate
D. None of these - Lower temperature and large excess of ammonia in urea melt__________________?
A. Increases biuret formation
B. Decreases biuret formation
C. Is undesirable
D. Does not effect biuret formation - Temperature and pressure in urea autoclave is_________________?
A. 120°C and 300 atm
B. 190°C and 200 atm
C. 400°C and 550 atm
D. 200°C and 10 atm - Dehydration of ammonium carbamate to yield urea is a/an __________________ reaction?
A. Exothermic
B. Endothermic
C. Autocatalytic
D. Catalytic
