A. Computing the excess/deficiency of combustion air
B. Calculation of flue gas temperature
C. Computation of flue gas analysis
D. None of these
Related Mcqs:
- Soaking pits are meant for heating steel_________________?
A. Ingots
B. Coils
C. Sheets
D. Slabs - In salt bath furnace, heat is transferred to the charge mainly by __________________?
A. Conduction
B. Convection
C. Radiation
D. None of these - Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the_________________?
A. Quantity & temperature of waste gas
B. Dust concentration & nature of dust in waste gas
C. Corrosive nature of the waste gas
D. All A., B. and C. - Presence of SO2 in furnace gases attacks the ferrous metal by way of_________________?
A. Accelerating the rate of scaling
B. Causing metal embrittlement
C. Attacking the grain boundaries; particularly severe on low carbon and nickel bearing steels at
high temperature
D. All A., B. and C. - Maximum thermal efficiency of boiler may be about _____________ percent?
A. 10
B. 25
C. 65
D. 90 - Which is not accomplished in an underfired furnace ?
A. Increase in heating capacity/m2 of floor space
B. Elimination of cold spot at the bottom of the charge
C. Reduction in the temperature of furnace gases
D. Protection of the periphery of the charge from excessive radiation - Means for giving direction to the circulation of gases in furnaces are_____________________?
A. Fans
B. Arrangement of heating stock in the furnaces
C. Location of outlet ports and heating & combustion devices
D. All A., B. and C. - Reducing atmosphere is maintained in a__________________?
A. Calcination kiln
B. Blast furnace
C. Soaking pit
D. L.D. converter - Which of the following is a heat treatment furnace ?
A. Muffle furnace
B. Annealing furnace
C. Reheating furnace
D. Rotary kiln - Which of the following furnaces will have maximum thermal efficiency ?
A. Soaking pits
B. Walking beam reheating furnace
C. Boiler furnace
D. Rotary kilns
