A. Pug
B. Ball
C. Tube
D. Rod
Related Mcqs:
- Water content in ground refractory material to be shaped into bricks by hand moulding is about ______________ percent?
A. 5
B. 20
C. 40
D. 55 - Sillimanite (Al2O3.SiO2) refractory, which is a neutral refractory, is not used in________________?
A. Pottery furnace
B. Glass melting furnace
C. Crucibles
D. Gas retorts - Firing of refractory brick is done to __________________?
A. Dehydrate the dried refractory
B. Develop stable mineral forms in them
C. Form ceramic bonds necessary for development of high crushing strength in the finished
product
D. All A., B. and C. - Fusion point of an acidic refractory material is________________?
A. Increased by the addition of basic oxides
B. Reduced by the addition of basic oxides
C. Not affected by the addition of basic oxides
D. Always more than 2500°C - High thermal conductivity of a refractory material is not important, when it is to be used in the______________________?
A. Coke oven regenerators
B. Muffle furnace
C. Blast furnace
D. Recuperators - Thoria is an expensive refractory material and is radioactive in nature. Thorium oxide is used in the manufacture of______________?
A. Segar cones
B. Muffles for muffle furnaces
C. Insulating bricks
D. Crucibles used for melting of high purity metals - Which of the following is not a high alumina refractory material ?
A. Kyanite
B. Sillimanite
C. Diaspore
D. Periclase - Fusion point of a basic refractory material is__________________?
A. Reduced by the addition of acid oxides
B. Increased by the addition of acid oxides
C. Not affected by the addition of acid oxides
D. Always less than 1000°C - Maximum water percentage in refractory mix meant for hand moulding may be as high as _____________ percent?
A. 2-3
B. 5-7
C. 7-12
D. 14-20 - An ideal refractory should have high__________________?
A. Spalling rate
B. Fusion point
C. Shrinkage ability
D. None of these
