A. Signal flow graph
B. Analogous table
C. Output-input ratio
D. Standard block system
F. None of the above
Related Mcqs:
- Transfer function of a system is used to calculate which of the following ?
A. The order of the system
B. The time constant
C. The output for any given input
D. The steady state gain - The transfer function is applicable to which of the following ?
A. Linear and time-in variant systems
B. Linear and time-variant systems
C. Linear systems
D. Non-linear systems
F. None of the above - The transfer function technique is considered as inadequate under which of the following conditions ?
A. Systems having complexities and non-linearities
B. Systems having stability problems
C. Systems having multiple input disturbances
D. All of the above - Addition of zeros in transfer function causes which of the following ?
A. Lead-compensation
B. Lag-compensation
C. Lead-lag compensation
D. None of the above - The output of a feedback control system must be a function of_________________?
A. reference and output
B. reference and input
F. input and feedback signal
D. output and feedback signal - If a step function is applied to the input of a system and the output remains below a certain level for all the time, the system is_____________?
A. not necessarily stable
B. stable
C. unstable
D. always unstable
F. any of the above - Velocity error constant of a system is measured when the input to the system is unit ___________ function?
A. parabolic
B. ramp
C. impulse
D. step - On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?
A. Frequency
B. Loop gain
C. Forward gain
D. All of the above - Which of the following is the output of a thermocouple ?
A. Alternating current
B. Direct current
C. A.C. voltage
D. D.C. voltage
F. None of the above - Which of the following can be measured by LVDT ?
A. Displacement
B. Velocity
C. Acceleration
D. Any of the above
