A. Carburetted water gas
B. Blast furnace gas
C. Natural gas
D. Producers’ gas
Related Mcqs:
- Oxygen required for theoretically complete combustion of 1 Nm3 methane is ______________ Nm3?
A. 2
B. 4
C. 6
D. 1 - Which of the following fuel gases will require maximum amount of air for combustion of 1 Nm3 gas ?
A. Blast furnace gas
B. Natural gas
C. Producer gas
D. Water gas - For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3), while the C.V. is same on weight basis (i.e., kcal/kg) ?
A. Propane and acetylene
B. Propane and LPG
C. Sewage gas and gobar gas
D. B.F. gas and coke oven gas - About _____________ Nm3 of air will be required for the complete combustion of 2Nm3 of CO?
A. 2
B. 3
C. 4
D. 5 - Dust content in raw blast furnace gas is about _______________ gm/Nm3; hence it is cleaned to the dust level of about < 10 mg /Nm3 before use?
A. 15-30
B. 1-2
C. 70-100
D. 150-200 - Dry air requirement for burning 1 Nm3 of CO to CO2 may be around _______________ Nm3 ?
A. 2.4
B. 1.75
C. 0.87
D. 11.4 - Supply of excess air for complete combustion of fuel is necessitated to facilitate___________________?
A. Its thorough mixing with air
B. Attainment of chemical equilibrium
C. Attainment of high temperature
D. None of these - Flue gas obtained on complete combustion of pure acetylene (a hydrocarbon fuel) will contain __________________?
A. CO
B. CO2
C. H2O
D. Both B. & C. - For the case of a fuel gas undergoing combustion with air, if the air/fuel ratio is increased, the adiabatic flame temperature will_____________________?
A. Increase
B. Decrease
C. Increase or decrease depending on the fuel type
D. Not change - Which of the following would require maximum amount of % excess air for complete combustion ?
A. Coke oven gas
B. Furnace oil
C. Pulverised coal
D. Lump coal (fixed on chain grate)
